1-18
IM WT310E-01EN
1.7 Storing Measured Data and Saving and
Loading Setup Parameters
Measured data and setup parameters are stored in internal memory.
Storing Measured Data (For procedures, see section 7.1)
All of the data obtained in a single data update interval is stored as a single block. The number of
data items varies depending on the number of equipped input elements. As a result, the number
of blocks that can be stored varies depending on the device. You cannot load and display stored
measurement data on the display of this instrument. You can use communication functions to send
stored measurement data to a PC, and you can then view the data on the PC.
Saving and Loading Setup Parameters (For procedures, see
section 7.2)
You can save four sets of setup parameters on this instrument.
You can load saved setup parameters and restore the saved settings.
To Next Page
Loading...
Need help?
General
