EasyManua.ls Logo

Yokomo TX3S - Power Alarm

Yokomo TX3S
8 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Receiver
受信機
11
11
11
Power Alarm
パワーアラー
12
12
12
YOKOMO TX3S 2.4GHz FHSS 3-channel Radio Control System
■受信機のバ
1.受信機のバボタンを続けす。
2.受信機のバインドボを押続けた状態で、車体の電源
を入れます。
3.送信機の電源を入れます。
4.受信機の LED が点滅すれば、バイ可能な状態とな
ています。
5.送信機と受信機のバイドが完了する、受信機の LED
が常灯とます。
6.バ 30 秒程掛かる場合があす。それでも完了
しな一度 1 5 の手順をさい。
■フイルセーフ設定
1.受信機のバイボタンを LED が点滅するまで押し続
ます
2.ストルステグの位置を調整さい。
3.受信機のバイタンを再度押ださい。調整
スロトルテアグの位置が登録さ、LED
点滅、その後常灯とす。
4.イルセーフ機能は、受信機が電波を受できない際
に、自定したストルとステア
置に固定されまれは電圧低下や電波が届かない際
に有効で
■無操作状態アーム : テアグやル、その他
のキーの操作が 15 分間行われなかた場合、ゆ
たピーといアラーム音がなり、電源落とれ防
止の機能ています。
■電池残量低下アラー : 短いピとアラーム音が
連続て繰返され、電源 LED が点滅ます
株式会社コモ
YOKOMOLTD.
305-0861 茨城県つば市谷田部 4385-2 TEL029-896-3888 FAX029-896-3889
4385-2Yatabe,TsukubaCity,IbarakiPrefecture,305-0861.JAPAN
TEL+8129-896-3888 FAX+8129-896-3889
202206v4.1
•Receiver Binding
1.Press and hold the "binding button" on the
receiver
2.While holding the binding button, turn the vehicle
power switch to On
3.Turn the transmitter switch to On
4.The LED of the receiver will blinks indicating that it
is searching for a transmitter to bind with
5.Once the transmitter and the receiver are bound
together, the receiver's LED light will turn solid
6.This may take up to 30 seconds, otherwise,
repeat step 1 to 5.
•Fail-safe Adjustment
1.Press and hold the receiver binding button until
the LED light flashes
2.Adjust the throttle trigger and steering wheel to
adjust the position
3.Press the binding button to program. Once the
position are programmed, the LED light will
flashes and stay solid
4.The failsafe function is to drive the servos (or ESC)
to a pre-programmed position once the receiver
cannot receiver the signals from the transmitter.
This can be due to low voltage from the battery
or radio interference.
•No Activity Alarm: When the steering wheel (ST),
throttle trigger (TH) or any button is not operated
for 15 minutes, a slow beeping alarm will sounds
to indicate that there has no action and the
power should be turned off.
•Low Battery Voltage Alarm: A quick beeping
alarm sounds and the power LED light will blink.
の送・受信機での同時走行可能台数は 15 台までです。
*Up to 15 transmitter / receiver units are available to run simultaneously.