Yokomo X Series - Installation Best Practices; Transmitter Settings and Calibration; Transmitter Configuration; ESC Calibration Procedure

6.Connection Install Guide
■ Locate the ESC in a safe place where is easily accessible to connector and buttons.
■ Tightly fi x the ESC with provided double-sided tape.
■ Make sure that there is some distance among the ESC, power wire and antenna / receiver. Try to avoid the direct
touch among such parts. If the receiver and antenna are too close to each other, then signal confusion might be
occurred. If this happens, re-install the parts with more distance.
7.Tran s m i t ter Set t ings
Before connecting the ESC to the receiver, check the transmitter settings are set as below. (Default settings)
Throttle Travel High ATV,EPA 100%
Brake Travel Low ATV,EPA,ATL 100%
Throttle Exponential EXP,EXPO Start with 0
Neutral Trim SUB Trim Center
Trigger RATE Forward-Brake F50 : B50
■ Make sure that the ESC is not connected to the battery and its power is OFF.
■ Remove the motor pinion, or check if the wheels rotate freely while the car is over (not touching) the surface.
8.CALIBRATION TO TRANSMITTER
■ Turn the transmitter on and place the throttle on the neutral.
■ Connect the ESC to the battery, and then turn the switch ON.
■ After the procedure above, then the ESC becomes possible to use.
■ If motor moves at neutral position, it means there is difference with saved neutral value. Re-calibrate the throttle
range.
■ It is possible to check the ESC settings are correctly done with the LEDs’ condition in accordance with the throttle
movement.
GREEN LED RED LED
Neutral ON OFF
Neutral(“BOOST OFF MODE”) Blinking OFF
Max Acceleration OFF ON
Max Reverse or Brake ON ON
Hold t he S ET b utton at l east f or 3
seconds. Release the button when GREEN
LED blinks. GREEN L ED t urns on with t he
motor sound. “Neutral Position Save”
RED LED turns on when throttle i s moved
forward to t he m aximum. “ Acceleration Full
Position Save”
Both G REEN a nd R ED L ED t urn on w hen
throttle i s moved backward t o the maximum.
“Brake or Reverse Full Position Save”
Green and RED LED blink by t urns w hen
throttle i s moved to “ Neutral Position” and
motor sound occurs.