Yokota WU-1 - Advanced Tool Configuration

76-QD7913EN-00Y00-03.doc
20
WORK SEL
Set contents
Selection
Default
Setting WORK SEL.
BIT：
DATA：
BIT
WAVE DATA OUTPUT
Set contents
Selection
Default
Setting ON/OFF of WAVE DATA OUTPUT.
ON: Output from the tool to the wireless unit.
OFF: No output from the tool to the wireless unit.
* To send output to external device from the wireless unit, set “WAVE DATA
DESTINATION” ON.
（see Cl. 7.2.3.3）
OFF
ON
OFF
SLEEP TIME
Set contents
Selection
Default
Setting SLEEP TIME.
0-100（min）
If “0” entered：Not sleep
* If YS-e controller board is
before Ver.1.01, 0-10(min)
1
LIMIT WORK
Set contents
Selection
Default
Setting the number of work to be used.
1：a
2：a,b
3：a,b,c
4：a,b,c,d
1
ID SETTING
Set contents
Selection
Default
Setting the ID number of the tool.
0～9999
0000