Yoli Sunset 170 User Manual

SETUP & TAKE DOWN INSTRUCTIONS
SUNSET 170 10’x10’ INSTANT CANOPY
SECURING THE CANOPY TOP TO THE FRAME
THANK YOU FOR PURCHASING A YOLI INSTANT CANOPY!
Please carefully review the following instructions and familiarize yourself with parts included
and how to operate your YOLI canopy. Reference parts list for names of each part noted in instructions.
Parts Included: Canopy frame (1), Canopy top with dual awnings (1), Canopy vent tops (2),
Steel shock cord poles (2), Steel shock cord bag (1), Wheeled carry bag (1), Stakes (4)
1
2
3
Take temporary protective sleeve as pictured in (Fig. 1A) off and discard.
Place the canopy in the desired location (Fig. 2A).
With partner, stand on opposite side of the frame. While holding the legs li slightly off the ground
taking a few steps backwards to extend frame at full arm’s length as shown (Fig. 3A).
Open the canopy frame to about 75% and pull the awning arms out until locks into 1st position as pictured in (Fig. 4A).
Drape the canopy top over the frame. Opening in the center of top accommodates canopy vent tops. Make sure long portions
of canopy top are on the two sides where the awning arms are located as pictured in (Fig.4B).
4
Secure top by attaching corner of the canopy top to black fastening strip (Fig. 5A). Repeat for all corners.
5
Attach the canopy top awning to awning arms by using the elastic loop as shown in (Fig. 6A).
Repeat for opposite side. Unlock awning arm from 1st position by puling on the ring pull pin. Your top is now secured to the frame.
6
2AFig. 3AFig. 4AFig. 4BFig. 1AFig.
5AFig. 6AFig.

Yoli Sunset 170 Specifications

General

Brand	Yoli
Model	Sunset 170
Category	Tent
Language	English

Summary

Securing the Canopy Top to the Frame

Secure Canopy Corners

Attach canopy top corners to black fastening strips for frame security.

Attach Awning to Arms

Connect canopy top awning to awning arms using elastic loops and locking pins.

Canopy Setup

Extend Frame Legs

Position and extend the canopy frame by lifting legs and stepping backward.

Open Airflow Vents

Adjust canopy top airflow vents by pulling up on the vent arms.

Lock Canopy Legs

Secure top corners by pushing down and lifting to engage leg latches.

Adjust Leg Height

Extend inner legs to desired height, ensuring awnings are fully extended.

Secure Canopy to Ground

Anchor canopy with stakes into feet or use weight bags for stability.

Setting Up Awning & Adjusting

Install Awning Pole

Extend steel shock cord pole and insert through the awning sleeve.

Attach and Adjust Awning Height

Connect awning to arm and adjust height, ensuring both sides match.

Canopy Take Down

Lower Awning Arms

Pull ring pin to lower awning arms to their lowest unlock position.

Remove Shock Cord Rods

Disengage and remove steel shock cord rods from awning sides.

Retract Inner Legs

Push chrome button on leg to unlock and retract inner leg into outer leg.

Unlock Ceiling Assembly

Pull ring pin at latch slider to unlock the ceiling assembly for closing.

Close Frame

Lift and walk towards each other to close frame, ensuring all latches unlocked.

Yoli Carry Bag Instructions

Pack Canopy into Bag

Close canopy completely, then place carry bag over it and zip shut.