Yolink YS7903-UC User Manual

5
C-2. Add Device
1. You will need to press the SET buon once again if the device failed to connect to the cloud
2. Pressing the SET buon at any other me aer this inial process will result in the LED blinking
red once, only. This indicates the device is connected to the cloud and is funconing normally
3. If the red LED does NOT blink as noted this may indicate a problem with the sensor. Please see
the troubleshoong secon and the contact secon for technical support
Press the SET buon once to turn
on the device. The Status LED will
blink red once, then green several
mes, indicang your device has
connected to the cloud and is
ready to use
2
You must press “Bind Device” to
pair the device to your account
Ta p “ ” i co n , t h e n s c a n Q R
C o d e o n t h e d e v i c e . F o ll o w t h e
s t e p s t o a d d t h e d e v i c e
1
SET Buon

Yolink YS7903-UC Specifications

General

Brand	Yolink
Model	YS7903-UC
Category	Accessories
Language	English