Wall-Mounting
Install wall anchor
in the wall
Install screw in anchor
(or nail in wall)
with about 1/8" gap left
Hang sensor on screw (or nail)
using the mounting slot
These items may be required for the wall-mounting:
Self-tapping screw
nail Wall anchor
HammerPhillips screwdriverDrill
Installation
F
If not already turned on, press the SET button once to turn on
the device. Place the sensor at the desired location.
1
2
Ensure your device is placed on a stable surface or mounted
securely on a wall or other surface.
Please refer to device environmental operating range
information on part M. Use this device outside the recommend
ranges at your own risk.
8
To Next Page
Loading...
Need help?
General
