brightness with the [Output control knob] within the range of ±3ev,
with the precision of 1/3ev. Please Note that this compensation
setting will override the exposure compensation setting on the
camera.
8. Reflection Flash
Bounce flash means to take photos by making flash light head
aimed at wall or ceiling and using the light reflected back from the
ceiling or wall to light the desired object, so that the shade behind
the object can be decreased to get more natural shooting effect.
If the wall or ceiling is too far,
the bounce flash may be too
weak to get enough exposure.
The wall or ceiling should be
even and white in order to get
efficient reflection; if the
reflection surface is not white,
color cast may appear in photo.
9. Use Reflection Board to Take Photos
With the reflection board flash, draw the reflection board and the
wide-angle diffusion board out from the light head at the same
time and then push the wide-angle
diffusion board back. In such case,
if this product is being used to take
photos, it will produce a
highlighted point on the eyes of
the subject and thus make the eyes
charming (catch light). This
function can reach optimal effect
when the flasher head is up 90°.
10. Use Wide-angle Diffuser
Pull out the wide-angle diffusion
board, push back the reflection board
and arrange them as per the figure; in
such case, the flash scopes will extent
to 18 mm and the flash effect will be
softer and more natural.
Note: When this product is used in incompatible iTTL/ETTL
camera, Functions 2, 3, 4, 5, 6 and 7 are not available.
To Next Page
Loading...
Need help?
General
