2. Channel Setting (Shortly Press [CH SET] Button)
Shortly press [CH SET] button and the channel indicator will keep
lighting for several seconds to indicate the current channel,
shortly press [CH SET] button again to change channel, and there
are totally 7 channels. Set all the transceivers at same channel.
Setting
Short press [GP SET] button to check
the current receiving group, then
shortly press [GP SET] button again to
change among A/B/C three groups.
8
3. Receiving Group Setting (Press [GP SET] Button)
1.Power switch
The YN622C II adopts 3 sections of power
switch design. When it set in the “622”
communication mode, the red indicator light
will bright, when set in the “560-RX’
communication mode, the orange indicator
light will bright, “OFF”for power off.
When it used with the YN622C series
products, please set the power switch on
“622”position,transmitting/receiving mode
will automatically switched. For the relevant
usage of 560-RX please refer to page 25.
Red Indicator
(622mode)
Orange Indicator
(560-RX mode)
To Next Page
Loading...
Need help?
General
