YOODA GAMMA X 1Cw User Manual

In order to fully explore available functions of GAMMA series please take a moment andread this manual before using the device.
GAMMA reciver are compatible with all YOODA brand devices.
Single-channel GAMMA X wall-mounted control unit (GAMMA_X_1Cw)
1. Control:
can control single motor
2. Memory:
up to 20 transmitters
3. Range:
200 meters outdoor,
35 meters indoor
4. Power supply:
230 V / 50 Hz
5. Output voltage:
230 V / 50 Hz
6. Output power:
500 W
7. Dimensions:
130 x 80 x 44 mm
8. Operating temperature:
from -20°C to 50°C
9. Protection degree:
IP 30
10. Work mode choice
(pulse or standard mode)
11. Switch connect.
(pulse or standard)
12. Lighting connect (max 250 W)
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
GAMMA_X_1Cw
www.sukcesgroup.pl
1. General information
2. Detailed description
1
LED diode (power)
LED diode (programming)
Programming button (S4)
Digital display
Programming button (S5)
Jumpers (set reaction of the unit to
the photocell signal and work mode)
Fuse 10A/250V
Screw clamps
J3 J1 J2
PA2
R25 R25
R36
S4

YOODA GAMMA X 1Cw Specifications

General

Brand	YOODA
Model	GAMMA X 1Cw
Category	Receiver
Language	English

Summary

General Information

Control Functionality

Details the capability to control a single motor.

Memory Capacity

Specifies the storage capacity for up to 20 transmitters.

Operational Range

Outlines the indoor and outdoor radio signal range limits.

Power Specifications

Lists the power supply voltage, frequency, and output voltage/power.

Physical Specifications

Covers the device dimensions and operating temperature range.

Protection and Modes

Details the protection degree and available work/switch modes.

Lighting Connection

Specifies the maximum wattage for the lighting connection.

Detailed Description and Components

Control Unit Components

Identifies key components like programming buttons, display, and LEDs.

Internal Components

Details internal elements such as jumpers, fuse, and screw clamps.

Connection and Installation

Wiring Diagram

Illustrates the connection of motor, power, and photocells to the unit.

Installation Guidelines

Provides safety and professional installation requirements for the device.

Photocell Wiring

Explains how to connect photocells to the GAMMA X receiver.

Programming Functions

Automatic Door Closing

Step-by-step guide to set the automatic door closing time.

Latching Mode Configuration

Procedure to enable or disable the latching mode for power supply.

Work Mode Programming

Configures the unit's operation between continuous and interrupted work.

Motor Direction Change

Instructions for reversing the direction of motor operation.

Transmitter Work Mode

Sets independent work modes (pulse/standard) for each transmitter.

Transmitter Management

Covers adding, deleting individual, or deleting all transmitters.

Switch Mode Selection

Guides on choosing between latching, non-latching, and impulse switch modes.