York 52051 - Adjusting the Resistance; Care & Maintenance

www.yorkfitness.com
14
Hand Pulse Sensors
This cross trainer is fitted with 2 hand pulse
sensors. To obtain a pulse reading you must
have both your left and right hands on the
sensors at the same time. Do not grip the hand
sensors too tight and allow the computer a few
seconds to display the reading.
Adjusting The Resistance
This cross trainer features a speed independent
braking (resistance) system. The resistance is
controlled by a magnet, which is moved closer
or further away from the flywheel - the closer
the magnet is to the flywheel the higher the
resistance. The magnet is computer controlled,
to adjust simply use the UP/DOWN dial on the
console.
Operational instructions
PE R FO RM
2 3 0
Hand Pulse Sensor
PE RF OR M
2 3 0
Resistance Level
Care & Maintenance
• This equipment should not be placed outdoors, in a garage or an outbuilding. Keep the
equipment in a dry place with as little temperature variation as possible.
• We recommend placing a mat beneath the equipment to protect both the equipment and
your flooring.
• Alwaysplacetheequipmentinadryenvironment.
• Useawarm,dampclothtokeeptheproductclean.
• Nowetcleaningofelectricalcomponents.Unplugbeforeanycareandmaintenance.
• Thesafetyleveloftheequipmentcanbemaintainedonlyifitisregularlyexaminedfor
damageandwear.Thisincludesanyropes,pulleys,nuts,bolts,movingparts,bushes,
chains,wheels,bearings&connectionpointsetc.
• Ensurethatyouinspecttheproductregularly-atleastonceaweekisrecommended.
• Ensurethatallxingsaretightbeforeuse.
• Alwaysreplacedamaged/worncomponentswithoriginalpartsfromthemanufacturer.