EasyManua.ls Logo

York Affinity DNP036 User Manual

York Affinity DNP036
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
CONTENTS
INSTALLATION SAFETY INFORMATION . . . . . . . . 4
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
RENEWAL PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . 4
APPROVALS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
SEQUENCE OF OPERATION. . . . . . . . . . . . . . . . . 17
START-UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
TYPICAL WIRING DIAGRAM NOTES . . . . . . . . . . 37
NOTES, CAUTIONS AND WARNINGS
Installer should pay particular attention to the words: NOTE,
CAUTION, and WARNING. Notes
are intended to clarify or
make the installation easier. Cautions
are given to prevent
equipment damage. Warnings
are given to alert installer
that personal injury and/or equipment damage may result if
installation procedure is not handled properly.
INSTALLATION
MANUAL
CAUTION: READ ALL SAFETY GUIDES BEFORE YOU
BEGIN TO INSTALL YOUR UNIT.
SAVE THIS MANUAL
AFFINITY™ SERIES
SINGLE PACKAGED GAS/ELECTRIC
AIR COOLED AIR CONDITIONERS
2, 2-1/2, 3, 3-1/2, 4 AND 5 NOMINAL TON
DNP024, 030, 036, 042, 048 & 060
280241-YIM-D-0909

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the York Affinity DNP036 and is the answer not in the manual?

York Affinity DNP036 Specifications

General IconGeneral
ModelDNP036
SEER Rating16
RefrigerantR-410A
Voltage208/230V
Phase1
Compressor TypeScroll
Sound Level74 dB
StagesSingle
TypeAir Conditioner
Cooling Capacity36000 BTU/h

Summary

Installation Safety Information

General Safety Guidelines

General recommendations for safe installation and operation.

Installation Requirements and Limitations

Installation Details: Clearances and Handling

Installation Details: Components and Wiring

Power and Control Wiring

Requirements for field wiring, grounding, and disconnects.

Gas Piping and Connections

Flue Venting and Gas Safety

Gas Piping Safety Precautions

Warnings and precautions for gas piping installation.

Sequence of Operation: Heating

Heating Control Logic

Control board logic for heating calls, pressure switch, and pre-purge.

Ignition and Flame Stabilization

Pilot ignition trial, flame stabilization, and blower delays.

Main Burner Operation Modes

High and low heat operation, including staging.

Sequence of Operation: Safety and Lockout

Post Purge and Blower Off Delays

Post-purge operation and indoor blower off delays.

Lockout Conditions and Resets

Conditions causing lockout and reset procedures.

Safety Controls and Faults

Limit switches, rollout, flame failures, gas valve issues.

Sequence of Operation: Cooling and Start-Up

Cooling Operation Logic

Thermostat control for compressor, outdoor fan, and circulating fan.

Unit Start-Up Procedures

Pre-start checklist and operating instructions for unit start-up.

Gas Valve Checks and Adjustments

Post-Start Gas Checks

Checks for gas leaks and manifold pressures after energizing.

Manifold Gas Pressure Adjustment

Adjusting the gas flow via the pressure regulator.

Burner and Pilot Adjustments

Gas Pressure and Pilot Adjustment

Adjusting manifold pressure and pilot flame.

Checking Gas Input

Natural Gas Input Measurement

Procedure for measuring natural gas input using the gas meter.

Related product manuals