3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In this case,
will blink,After that,press Enter/Cancel
to make a conrmation.
Swing Off: When the Swing function is on, press Function to enter the Swing setting interface,with blinking. After that, press
Enter/Cancel to cancel this function. Swing setting is shown below in Fig.3.6.1.
Notes:
(1)Sleep, Turbo or Blow setting is the same as the Swing setting.
(2)After the setting has been done, press the key “Enter/Cancel” to go back to the setting status or quit automatically five seconds later.
3.7 Sleep Setting
Sleep on: Press Function under the On state of the unit until the unit enters the Sleep setting state. After that, press Enter/Cancel
to confirm this setting.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting status. After that, press Enter/Cancel to cancel
this function.
In the Cooling or Dry mode, the temperature will increase by 1°F~2°F (1°C) after the unit runs under Sleep1 for 1hr and 1°F~2°F
(1°C) after another 1hr. After that, the unit will run at this temperature.
In the Heating mode, the temperature will decrease by 1°F~2°F (1°C) after the unit runs under
Sleep 1 for 1hr and 1°F~2°F (1°C) after
another 1hr. After that, the unit will run at this temperature.
Timer range: 0.5-24hr. Every press of ▲or ▼ will make the set time increased or decreased by 0.5hr. If either of them is pressed
continuously, the set time will increase/ decrease by 0.5hr every 0.5s.
Fig. 3.6.1 Swing Setting
To Next Page
Loading...
