5
Assembly instructions
Care & Maintenance
This equipment should not be placed outdoors, in a garage or an outbuilding. Keep the equipment in a dry
place with as little temperature variation as possible.
Always place the equipment in a dry environment.
Use a warm, damp cloth to keep the product clean.
No wet cleaning of electrical components. Unplug before any care and maintenance.
The safety level of the equipment can be maintained only if it is regularly examined for damage and wear. This
includes any ropes, pulleys, nuts, bolts, moving parts, bushes, chains, wheels, bearings & connection points etc.
Ensure that you inspect the product regularly - at least once a week is recommended.
Always replace damaged / worn components with original parts from the manufacturer.
Prepare your work area - It is important you assemble the product in a clean and uncluttered space.
Work with a friend - We recommend you have someone assist you with the assembly as some
of the components are quite heavy.
Open the carton - Check any warnings on the carton and make sure you have it the right way up.
Unpack the carton
Blister Pack
P-6 x 2
Rubber Stopper
P-5 x 2
Foot Pedal Spacer
P-14 x 3
Truss Head Screw M6*40
P-9 x 6
Flat Washer Ø8.5*Ø16*T1.5mm
P-1 x 4
Carriage Bolt M8*50mm
P-16 Allen Key L6
P-17 Allen Key L6 w/ Philip Head
P-12 x 1 / P-13 x 1
Aluminum Track End Cap (L/R)
P-11 x 4
Truss Head Screw M5*10mm
P-8 x 2
Flat Washer Ø8.2*Ø22*T2.0
P-10 x 2
Hex Socket Button Head Screw M8*20
P-4 x 4
Domed Nut M8
P-2 x 4
Allen Head Bolt M8*15
P-3 x 4
Nylon Nut M8
P-7 x 1
Roller Pivot Shaft
P-15 Box Spanner 13/17
To Next Page
Loading...