EasyManua.ls Logo

York RMHC 18-30 - Cautions on Remote Controller Installation; Remote Controller Placement Guidelines

York RMHC 18-30
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
8
C
B
9
A
6
2
4
3
1
6
2
4
3
1
10
2
4
1
3
5
5
6
A1 Unit
INDOOR UNIT
B Unit
Mounting screw A
ST3.9x25-C-H
Clip anchor
4.3cm
Installtion plate
>12cm
>17cm
Air filter
Mounting screw B
ST2.9x10-C-H
Remote controller
holder
Remote
controller
Installtion plate
4.3cm
Mounting screw A
ST3.9x25-C-H
Clip anchor
>12cm or m
ore
>17cm
Air filter
Remote
controller
Remote controller
holder
Mounting screw B
ST2.9x10-C-H
ST3.9x25-C-H
Clip anchor
Installtion plate
4.3cm
>12cm
>17cm
Air filter
Mounting screw B
ST2.9x10-C-H
Remote
controller
Remote controller
holder
OUTDOOR UNIT
>60cm
>20cm
>
100cm
>100cm
>
6
0
c
m
Mounting screw C
ST3.9x10-C-H
Water tray
>20cm
Loop the connective
cable (about 300mm
long)
A2 Unit
Note:
Connect the auxiliary pipe
of the three indoor units to
the stop valves as identi ed
with their respective matched
numbers A1, A2, and B on the
outdoor unit. After nishing
connection, the indoor units
must be marked relative
number A1, A2 and B.
Model 27-30
NOTE: At least two of A, B, C aspect are free from
blocking.
The air conditioner can be connected only to a supply
with system impedance no more than 0.26 ohm. In case
necessary please consult your supply authority for system
impedance information.
Cautions on remote controller installation
Before installation, operate the remote controller to
determine its location in a reception range.
Keep the remote controller at least 1 m apart from the
nearest TV set or stereo equipment.
Do not install the remote controller in a place exposed
to direct sunlight or close to a heating source, such as a
stove.
Note that the positive and negative poles are right
positions when loading batteries.
Model 27-30
Number Name of part Q’ty
1 Installation plate 3x1
2 Mounting screw A. 3x8
3 ST3.9x25-C-H Clip anchor 3x8
4 Remote controller 3x1
5 Mounting screw B. 3x2
6
ST2.9x10-C-H Remote controller holder
3x1
7 Seal 3x1
8 Drain elbow 1x1
9 Mounting screw C ST3.9x10-C-H 1x2
10 Water tray 1x1
J287-EN.indd 8J287-EN.indd 8 07.03.2006 9:30:12 Uhr07.03.2006 9:30:12 Uhr

Related product manuals