York SUNLINE 2000 H2CE120 User Manual (English)

To Next Page

036-21083-007-A-0404

FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE

TECHNICAL GUIDE

SPLIT-SYSTEM AIR-COOLED

CONDENSING UNITS

SUNLINE 2000™

MODELS: H5CE090, H3CE120 & H1CE150

7-1/2, 10, & 12-1/2 NOMINAL TONS

9.0-9.5 EER

DESCRIPTION

These Sunline 2000™ units are completely assembled, piped

and wired at the factory to provide one-piece shipment and

rigging. Each unit is pressurized with a holding charge of

refrigerant-22 for storage and/or shipping.

The compact design, clean styling, low silhouette, and quiet

operation make these condensing units suitable for almost

any outdoor location. On rooftops…because they weigh

much less than a single package unit of similar capacity and

are much easier to rig and support. At ground level…because

their ample sub-cooling capacity allows them to be located 60

feet below the evaporator coil.

All sheet metal parts are constructed of commercial grade

(G90) galvanized steel. After fabrication, each part is thor-

oughly cleaned to remove any grease or dirt from its sur-

faces. The external parts are coated with a powder paint to

assure a quality finish for many years. This coating system

has surpassed the 500 hour, 5% salt spray test per ASTM

Standard B117.

All models include a 1-year limited warranty on the complete

unit. The compressor carries an additional 4-year warranty.

A complete line of Evaporator Blower units is also offered to

meet your precise capacity and air handling requirements.

Refer to Form 036-21300-001 for more information on this air

side equipment.

FEATURES

• Condenser coil constructed of copper tubes and aluminum

fins for durability and long lasting efficient operation.

• Permanently attached base rails with fork-lift slots and lift-

ing holes. This design allows for 3-way fork-lift access and

overhead rigging.

• Both high and low pressure controls. Since these controls are

self-contained, there are no capillary lines to be damaged.

• Compressor line-break motor protection and crankcase heat-

ers. (No crankcase heater on H*CE150 compressors.)

• Anti-short cycle timer to protect the compressor.

• A lockout circuit to prevent the unit from cycling on safety

control.

• A 24-volt temperature control circuit.

• Low ambient operation to 45

°F accessories for 0°F low

ambient operation are available.

• A filter-drier (shipped in the unit's compressor compart-

ment for field installation near the evaporator coil).

• Service valves with a back-seating access port for pres-

sure testing the system. Copper stub-outs are factory

mounted on the suction and liquid service valves to sim-

plify the field piping connections.

• Separate panel for easy access to the control box without

affecting air flow across the condenser coil.

• Gauge lines extend out from cabinet to facilitate servicing.

• Packaging suitable for outdoor storage

• Optional coil guard accessory protect coils with a decora-

tive grille.

Need help?

Do you have a question about the York SUNLINE 2000 H2CE120 and is the answer not in the manual?

York SUNLINE 2000 H2CE120 Specifications

General

Model Number	H2CE120
Category	Air Conditioner
Series	SUNLINE 2000
Cooling Capacity	12000 BTU/h
Energy Efficiency Ratio (EER)	10.5
Refrigerant	R410A
Operating Temperature (Cooling)	18°C to 43°C
Noise Level (Indoor/Outdoor)	52 dB
Net Weight (Indoor/Outdoor)	32 kg
Power Supply	220-240V, 50Hz