York TIWM006B21S - Conduit Connection

P5417052
31
8.5 Conduit Connection
The conduit connection for this unit is shown below. Remove the front panel to connect the conduit.
TIWM006B21StoTIWM012B21S
(1) Hold both sides of the at panel and lift it up.
Open the at panel fully and slightly extend the right arm shaft outward. After the shaft is removed from
the front panel, pull the at panel and remove it.
Press inward two portions as shown to remove the lower right corner cover.
Press
Press to
remove
Flat Panel Electrical Box Cover
Lower Right Corner Cover
(2) Remove the two (2) screw caps and then the two (2) screws on the lower side of the front panel. Pull
the lower side of the front panel forward to release the catch-tting. Use caution when removing this
panel so as not to make contact with air outlet louver.
Screw
Front Panel Holes
for Catch-Fitting
Screw Cap
Catch-Fittings for Lower
Side of Front Panel
Condensate Pan Fitting
Do not use excessive force when disassembling.
(3) Slightly lift the front panel up to release the catch-tting (at four locations) on the upper side of the unit.
Then pull the front panel forward to remove it.
(4) Remove the screw securing the electrical box cover and open it.
Electrical Box
Cover
Switch Cover
Remove this screw
Unit
Electrical Box Cover
Switch Cover