To Next PageTo Next Page
Need help?Do you have a question about the York TIWM018B21S and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Voltage | 208/230V |
| Power Supply | 1 Phase, 60 Hz |
| EER (Energy Efficiency Ratio) | 12.5 |
| Noise Level (Indoor Unit) | 42 dB(A) |
| Cooling Capacity | 18000 BTU/h |
| HSPF Rating | 9.0 |
| Dimensions (Outdoor Unit) | 31.5 x 21.3 x 11.8 inches |
Overview of the installation and maintenance manual's purpose and scope.
General safety guidelines, signal words, and specific precautions for installation and operation.
Procedures for unit transport, handling, and identification of included accessories.
Selecting optimal locations considering airflow, clearances, and controller signals.
Steps for mounting the plate and securing the indoor unit to various wall types.
Instructions for safely removing and attaching the front flat panel for access.
Details on connecting gas and liquid pipes from different directions with dimensions.
Guidance on pipe preparation, flaring, tightening, and leak testing.
Steps for connecting condensate piping, ensuring proper drainage and insulation.
Pre-wiring checks, wire sizing, GFCI, and breaker recommendations.
Diagrams showing wiring connections at the indoor unit terminal blocks.
Instructions for connecting conduit for power and communication wiring.
Setting DIP switches for unit number, capacity, refrigerant cycle, and optional functions.
How to select and change unit functions using the wired controller interface.
Steps to configure setback operation using the wired controller and card key input.
Comprehensive guide for performing test runs with both wired and wireless controllers.
Table of alarm codes, their causes, and troubleshooting steps.
