18
Installation procedure
MOUNT THE COVER PLATE AND THE INTAKE GRILL
2. Mount the cover plate (left)
Join the cover plate (left) and mount with screws.
3. Mount the intake grill.
Cover plate (right)
1.Mount the cover plate (right)
(1) Cut a pipe exit hole in the right plate. This is only
when the pipe exits from the right side. This operation is
not required when the protrusion is on the top or rear.
(2) Join the cover plate (right) and mount with screws.
(2) Insert the hinges on the bottom of the intake grill into
the holes in the base assembly. Then mount the arms
to the three areas on the top of the intake grill.
(1) Cut the right side of the intake grill. This is only
when the pipe exits from the right side
31
Fig.17
Fig.18
Fig.19
Fig.20
Fig.21
To Next Page
Loading...
