EasyManua.ls Logo

York YST - Page 82

York YST
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
JOHNSON CONTROLS
82
FORM 160.67-O2
ISSUE DATE: 10/9/2020
SECTION 7 - PREVENTIVE MAINTENANCE
PROCEDURE DAILY WEEKLY MONTHLY YEARLY
CHILLER
Record Operating Conditions (On Applicable Log Form) X
Check Oil Levels X
Check Refrigerant Levels X
Check Oil Return System Operation X
Check Sump Heater And Thermostat Operation X
Check Three-Phase Voltage And Current Balance X
Verify Proper Operation/Setting/Calibration Of Safety Controls
1
X
Verify Condenser And Evaporator Water Flows X
Leak Check And Repair Leaks As Needed
1
X
Check And Tighten All Electrical Connections X
Replace Oil Filter And Oil Return Filter/Driers X
Clean Oil Cooler Heat Exchanger Tubes X
Perform Oil Analysis On Compressor Lube Oil
1
X
Perform Refrigeration Analysis
1
X
Perform Vibration Analysis X
Clean Heat Exchanger Tubes X
2
Perform Eddy Current Testing And Inspect Tubes 2-5 Years
Check Operation of all Shutdowns (History Print) X
Conduct Panel Overspeed Test X
Check Operation of Motor Contactors in Power Panel X
STEAM CONDENSER
Visually Inspect For Leaks / Abnormal Noise X
Check Liquid Ring Seal On Relief Valve &
Liquid Ring Vacuum Pumps
X
Check Conedsate Pump Operation / Seals X
Check Hotwell Liquid Level / Pump X
Lubricate The Hotwell Pump Bearing 6 Months
Check And Tighten All Electrical Connections X
Check Three-Phase Voltage And Current X
Inspect / Clean Tubes With Chiller Heat Exchangers X
Clean And Grease Vacuum Pump Bearings
3 Years
MAINTENANCE REQUIREMENTS FOR YORK YST CHILLERS
160.67-MR1 (614)
Issue Date: 6/20/2014

Table of Contents

Other manuals for York YST

Related product manuals