Need help?Do you have a question about the YORKVILLE BassMaster XM200 and is the answer not in the manual?
Read and understand the Owner's Manual before operating the unit.
Keep packaging materials for potential service returns.
Connect unit only to the specified voltage source; handle polarized plugs carefully.
Avoid unstable placements and protect from liquids and heat sources.
Ensure the power cord is not damaged; do not operate if it is.
Servicing should only be performed by qualified personnel.
Instrument-level output for connecting a guitar/bass tuner.
Inputs for passive/active pickups; use -6dB for hot/active pickups.
Cuts audible signal, allowing tuning without affecting audience.
Prevents power amp clipping by reducing signal before output stage distortion.
Adjusts the desired sound level; reduce if distortion occurs.
Adjusts bass, low mid, hi mid, and treble frequencies for desired tone.
Blends in a unique sound alternative for expanded tonal range.
Connects external effects units to the amplifier.
Interface to PA or recording console; provides balanced output.
Configures the Line/DI Output behavior (DI for dry signal, Line for affected signal).
Disconnects internal speaker for silent practice.
Indicates unit status via a blue LED next to the power switch.
Connects one or two external speakers; minimum 4-ohm impedance.
To Next Page
General