Need help?Do you have a question about the YORKVILLE Audiopro 3000 and is the answer not in the manual?
Describes the function of the MONO/STEREO switch, routing channel 'A' to both amplifiers when engaged.
Details power output values at different frequencies and loads, measured under specific conditions.
Explains burst average measurements and their relation to continuous measurements and line current.
Table showing continuous average, burst average, peak instant, and FTC 20-20KHz power for one channel.
Table showing power output when both channels are driven simultaneously into various loads.
Table detailing power output when the amplifier is operated in bridged mode into various loads.
Provides Total Harmonic Distortion figures at 1 KHz and 20 Hz - 20 KHz for different load impedances.
Specifies crosstalk levels between channels at different frequencies.
Lists the input impedance for both balanced and unbalanced connections.
States the input voltage required for full power output and the associated gain.
Provides the Common Mode Rejection Ratio for balanced inputs.
Lists the front panel controls available on the amplifier.
Lists the LEDs and indicators present on the amplifier's front panel.
Specifies the frequency response within a given tolerance.
Symptom of no AC power, with probable solutions.
Symptom of no audio output, with potential causes like input signal or faulty cables.
Symptom indicating the amplifier might be in mono mode, with solution to switch to stereo.
Symptom indicating a short circuit or load less than 2 ohms, with troubleshooting steps.
Symptom of energy management system correcting for excessive current draw or amplifier overheating.
Symptom of amplifier overheating, with solution to clear ventilation obstructions.
To Next Page
General