To Next PageTo Next Page
Need help?Do you have a question about the YORKVILLE AudioPro AP3000 and is the answer not in the manual?
General| Slew Rate | >20V/µs |
|---|---|
| Cooling | Variable Speed Fan |
| Signal to Noise Ratio | >100dB |
| Frequency Response | 20Hz-20kHz (+/-0.5dB) |
| Input Impedance | 20k Ohms balanced |
| Input Impedance Unbalanced | 10k Ohms |
| Input Sensitivity | 1.4V |
| Crosstalk | >70dB |
| Protection | Thermal, short circuit, DC, overload |
| Connectors (Input) | XLR, 1/4" TRS |
| Connectors (Output) | Speakon |
| Power Consumption (Typical) | 1200W |
| THD | <0.05% |
Essential safety warnings for product operation and servicing.
Critical instructions to prevent fire, electric shock, or injury.
Processes audio signal, gain stages, filters, and interference elimination.
Details voltage amplifiers, control circuitry, and signal path explanation.
Manages amplifier shutdown via relay for protection or turn-off.
Receives audio, drives speakers, explains biasing and equilibrium.
Describes varying power supply voltage for efficiency and signal compensation.
Triac circuit to hold output at ground if DC voltage exceeds limits.
Simulates SOAR curve to protect output transistors from excessive current.
Manages AC line current draw for North American products.
Controls fan speed based on thermistor temperature on M1002 boards.
Shuts down amplifier if heatsink temperature exceeds safe limits.
Steps for inspecting front panel, fan, and internal chassis for issues.
Steps for powering up the unit without M1002 boards connected.
Guidelines for safely removing and reinstalling circuit boards.
Details power output, THD, crosstalk, input impedance, and sensitivity.
Covers frequency response, hum/noise, slew rate, damping factor, and dimensions.
