Step 4: Install the Seat
Required parts:
#2- Seat #3- Seat Slider #6- Plum blossom knob
#65- Allen Wrench #70-Washer
1. Unscrew the #6- Plum Blossom Knob on the #3- Seat Slider, put #3- Seat Slider on the
#7-Seat Post.
2. Adjust the #3- Seat Slider to the desired position, put the #70-Washer to #6- Plum
Blossom Knob, re-insert and tighten #6- Plum blossom knob to secure the slider in place.
3.Place the #2- Seat on the #3- Seat Slider. Use #65- Allen Wrench to clockwise tighten the
nuts on both sides of the #2- Seat.
NOTE: Before you fully tighten the seat, you can adjust the front of the seat higher or lower
to meet your needs.
To Next Page
Loading...
Need help?
General
