◆
Handlebar Installation (Requires a 4mm Hex Wrench)
7
Assembly Instructions
Step 1: Gently loosen the bolts on your bike's stem.
Step 3: Partially tighten the bolts on the handlebar stem, leaving enough slack for adjustments. Fine-tune the angle and check the positioning by testing it out.
Once satisfied with the handlebar's angle, securely tighten all bolts on the stem.
Step 2: Align your handlebars to the central marking as indicated in the image provided below.
IMPORTANT NOTICE:
While adjusting the angle, you may also modify the
handlebar height by adding or removing headset
spacers. If you're not familiar with this process,
we highly recommend seeking a professional's
assistance for safety reasons.
To Next Page
Loading...