Assemble the power transistor assembly to the main board , with the power transistor
leads in the pads. Fasten the aluminium to the stands-off.
You can solder the 3 leads easily. No screws are needed in the 2 top mounting holes.
Now, put on the PTT button. Plug in the DC cord, and connect the antenna. Switch on the
power.
Does the rig work? Yes. OK. Press PTT and talk to the MIC. Output power can be
observed on the power meter. The MIC opening is very small, so the internal MIC is not
very sensitive. For better performance, please use an external MIC.
Now you can close the bottom and back covers.
To Next Page
Loading...
