6. Dis-assemble the rig
You may want to improve the kit, or the kit needs repair some day. You have to open the
enclosure and take out the main board. Dis-assemble the kit reverse operation.
1) Pull out the PTT button. Remove the screws and open the back cover.
2) Remove the two screws to fasten the aluminum plate. Lift the aluminum plate a little
until you can reach the two brass stands-off, and remove the stands-off. Remove the
screws that fasten the top cover and the bottom cover. Take away the bottom cover. You
may need to unsolder the two wires connected to ANT so that you have more room to lift
the left corner. Lift the main board with two of your fingers as indicated.
To Next Page
