10
BoSS X-Series Instructions for Use
2.2.4 SEGREGATION FROM OTHER SITE
VEHICLE MOVEMENTS
2.2 OPERATING SITE
When a BoSS X-Series machine is delivered
to site ensure that the machine will be able to
reach the work area; these are not rough terrain
machines and should not be transported across
unstable or uneven ground as this could cause
significant damage to the machines. It is good
practice to walk the route from the machines
parking place to the workplace.
A visual inspection of the operating area should
be made before setting up the machine paying
particular attention to the following issues:
2.2.1 GROUND CONDITIONS
Ensure that the ground on which the BoSS
X-Series machine is to operate is capable of
supporting the weight of the machine (including
the maximum rated load of 240kg). Be aware
of specific floor areas such as manhole covers
which may not be designed to withstand the
following maximum point loading exerted by the
castor wheels:
BoSS X3X – 160kg
BoSS X3 – 150kg
BoSS X2 – 140kg
2.2.2 GROUND FLATNESS
Ideally the BoSS X-Series machine should
be operated on flat surfaces resulting in a 0
degree chassis inclination. However, the BoSS
X-Series machine can be safely operated where
the ground is slightly uneven resulting in the
following maximum lateral and longitudinal
inclinations:
BoSS X3X – 1.25
0
BoSS X3 – 1.5
0
BoSS X2 – 1.5
0
The BoSS X-Series machines are fitted with
a tilt sensor and will not raise if this angle is
exceeded.
All four castor wheels must be in contact with
the ground at all times.
2.2.3 OVERHEAD OBSTRUCTIONS
Ensure that adequate clearance is available
above and all round the platform before
deployment and elevation and pay particular
attention to the presence of live electrical
cables.
Every worksite should be subject to a risk
assessment and where vehicle movements
are likely to occur close to the BoSS X-Series
machine, measures should be taken to
segregate the machine from other vehicles.
This might include the use of cones, barriers,
signage and re-routing measures.
2.3 NOISE AND VIBRATION
The maximum noise level emitted by a BoSS
X-Series machine is 75.8dB(A)
Hand and arm vibration expearienced on
a BoSS X-Series machine does not excead
2.31m/s
2
2.4 LIMITATIONS
The BoSS X-Series machine is limited to indoor
operation and must not be used outdoors.
Please consult us direct if you are unsure about
any application for which the machine is being
considered.
The machine has been tested for
Electromagnetic Compatibility (EMC) however,
operation near to high powered radio
transmission apparatus (eg radar, antennae)
or within strong electrical and/or magnetic
fields may affect some of the features of this
machine.
WARNING
This machine has not been designed for
operation in a hazardous environment where
ammable or explosive gases or particulates
are present. Advice should be sought from the
person in charge of the site regarding the need
to select MEWP’s that are designed for use
in the hazardous environment and the use of
suitable personal protective equipment. Expert
advice may need to be sought.
This machine is not electrically insulated and
must never be used for live line working.
Death or serious injury can result from contact
with, or inadequate clearance from, electrical
conductors.
The risk assessment carried out as part of the
planning process when considering the use of
a BoSS X-Series machine should take account
of the particular hazards of lone working. Of
particular concern is the rescue of the occupant
from the platform in the case of machine
malfunction, work platform entanglement or a
medical emergency. Guidance on lone working
is given in the HSE leaet INDG 73 [20].
To Next Page
Loading...
Need help?
General
