1
1.1 INTRODUCTION
This Maintenance Manual provides the necessary
information to enable maintenance to be undertaken
on BoSS X-Series single person push around
micro scissor lifts. Maintenance engineers should
read and understand all the information contained
in this manual before carrying out work on any
BoSS X-Series machine.
This manual does not apply to BoSS X3 machines with
serial numbers between YMG 11001 and 11300.
Additional copies of this Maintenance Manual may
be obtained from Youngman Group Ltd., please
see contact details in Section 1.3 on this page.
The manual is also available to download from our
website at youngmangroup.com.
1.2 INTENDED USE
BoSS X-Series machines have been designed to comply
with the safety requirements of the European Machinery,
Low Voltage and Electromagnetic Compatibilty Directives
and in accordance with the European Standard EN 280
Mobile Elevating Work Platforms – Design calculations –
Stability criteria – Construction – Safety – Examinations
and tests.
BoSS X-Series machines are intended to lift one person,
plus essential tools and materials, to enable work to
be undertaken at height. BoSS X-Series machines are
designed for indoor use only and must be used on
level ground which is able to support the weight of the
machine and its maximum safe working load. Typical
applications include maintenance, cleaning, painting, fit
out work etc. at varying heights above ground level.
WARNING
The user must obtain the guidance and written approval of
Youngman Group Ltd in the event of any special working
methods or conditions which are outside those specied
in this section.
1.3 MODIFICATIONS
No modifications shall be made to any BoSS X-Series
machine unless Youngman Group Ltd. has given full
written approval. If in doubt please contact us for advice:
Youngman Group Ltd.
The Causeway
Maldon
Essex
CM9 4LJ
United Kingdom
t +44 (0) 1621 745900
f +44 (0) 1621 859845
e sales@youngmangroup.com
SECTION 1 – DESCRIPTION, SPECIFICATION AND OPERATION
To Next Page
Loading...
Need help?
General
