planed. This mode guarantees constant running time of the program, but it can’t
guarantee the integrity of the whole curve.
D=1, With the function of PV startup and without the function of preparation.
D=2 With the function of preparation and without the function of measurement value
startup.
D=3 With the function of measurement value startup and preparation.
For details about PV startup function and PV preparation function, see program
instruction later chapter.
For example: if it is needed that the instrument continue program running from the
original break point after power on, have the function of measurement value start up
and preparation, then you can set as below: A=2,D=1, and so we get parameter:
Run=2×1+3×8=26
To Next Page
Loading...