can be used for calibration of compensation errors of the thermocouple
interior (INT) reference ends.
b) When the menu parameter CAL.Cod is equal to 5500, pressing “Key 4”
for long can restore the factory calibration datum and settings.
3) In the menu parameter setting state, “Key 4” is the increase key.
Menu Settings
Press “Key 1” (i.e. SET key) and hold it for 2 seconds to enter the menu. Once
“Set” key is pressed briefly, the parameter name is displayed first, then if “Set”
key is pressed again the parameter value will be displayed which can be modified
with the keys of
.
The set menu parameters are saved when exiting the menu. The set parameters
will not be saved in case of low battery voltage (“LOWBAT”) or automatically
exiting the menu without key-press for 30 seconds.
The menu settings are as follows.
15
To Next Page
Loading...