AI-518P has the advanced function of flexible program arrangement. Normally, when the program
stops, the StEP will be automatically set to1. Thus if StEP is not change to other value, a program will start
from step1. If multiple curves are defined, the control can jump to different curve by setting step 1 as jump
segment.
For example: There are three curves with the length of 3 steps represent three groups of process
parameter, they are separately arranged on StEP2-StEP4, StEP5-StEP7, StEP8-StEP10. Settings are as
follows:
T 1=-2 Execute the program of curve 1 (StEP2-StEP4)
T 1=-5 Execute the program of curve 2 (StEP5-StEP7)
T 1=-8 Execute the program of curve 3 (StEP8-StEP10)
Note: t 1 setup can be omitted, if you choose the curves by setting the value of StEP before the program
startup.
To Previous Page
Loading...
