7、Start to Run 使用说明
1）Connect cables
输入及输出电源连接
Connect to main input power, signal input from injection machine, output to mold.
Make sure the main input voltage (see rear of time case), output voltage to mold.
按照时间控制器的电源式样(请参考外壳后部)连接电源线与输入,输出线。
2）Power LED is blinking while power on.
输入电源时POWER LED闪灯。
3）Switch between actions
工作状态转换
A. Press key.
按 键启动电源。
a. POWER LED blinks.
POWER LED 闪灯。
b. Display delay time value and open time value at each display panel.
根据GATE的延迟时间及OPEN时间，把所设置标在GATE上。
4）Switch between MODE A/MODE B and gate off.
mode A/ mode B 及窗口off 转换。
A. Press for 4 seconds.
按４秒左右 键。
a. Buzzer rings and mode LED blinks.
响警告声，MODE LED 闪灯
b. MODE LED of 1st gate blinks.
1号GATE的MODE LED 闪灯
c. Hit , to switch MODE A/B and gate off.
MODE A/B及GATE OFF 的转换是利用 , 转换。
d. MODE A or B LED blinks，Both MODE A and B LED blink when gate off.
转换时相关MODE A/B 的LED 闪亮，GATE OFF 时MODE A/B全部闪亮。
e. Move using , between GATE.
GATE选择是利用 , 移动自己需要的GATE。
f. When move, MODE A or B LED is Blinking in the gate.
移动时相关GATE的MODE A或者MODE B LED闪灯。
4
POWER
POWER
MODE
MODE
USER’S MANUAL
To Next Page
Loading...
Need help?
General