Power ON/OFF
Turn on the ST16E, and then press the power button on H520E/H520E-RTK. Release the button
when the aircraft emits a rising tune. Power the ST16E before powering on the UAS.
OFDM Module Re-bind
The aircraft and ST16E Ground Station are already bound out of factory. There is no need to
bind them. Pilot can follow the steps below if rebinding is needed.
Step 1: Power on the ST16E. Wait a few seconds for all systems to be boot up.
Step 2: Tap the OFDM logo on the top right corner, then Tap the unbind button.
To Next Page
Loading...
