Z-CAM E2 Flagship Series User Manual

 UART Role2
：
Controller / Pelco D / Multiplexer / Linear TC, can set separately:
- Controller: The camera will be controlled by UART command from a computer
through COM port.
- Pelco D
：
The camera will control the external device like a gimbal through COM
port with Pelco D protocol.
- Multiplexer
：
Need 3
rd
-party device to support.
- Linear TC: to be supported with extra accessories later.
2.10. System
 Clear Settings
：
Clear all the Settings in the camera and set them to default values.
 Format Card
：
Format the CFast card or the external SSD connected through USB
Type C port (if there is no CFast card in the camera). Please note that formatting
will erase ALL DATA in the storage!
 Assist Tools: There is three sub-items in this setting: Display / Scope / Peak /
Exposure / Frame Line / Center Mark / Grid Line / Safe Area
 Display: On / Off. To enable or disable the assist tool on the display. Please
note that when the assist tool is enabled, the effect will be output through HDMI
together with the video stream. So you would need to turn it off if you are using
external recorder though HDMI connection.

Scope: Tool / Opacity / Measure
-Tool: Disable / Waveform / Parade / Vectorscope / Histogram, HDMI output

Z-CAM E2 Flagship Series Specifications

General

Brand	Z-CAM
Model	E2 Flagship Series
Category	Digital Camera
Language	English