What to do if nothing happens when I try to print with Z Corporation Spectrum Z 510 3D Printers?
If nothing happens when you try to print with your Z Corporation 3D Printer, first, check the network connection by removing and carefully reinstalling the cord. If that doesn't work, try rebooting the printer. If the control pad illuminates but nothing happens, shut the machine off and turn it back on again.
General| Materials | Powder-based materials (e.g., zp150, zp131) |
|---|---|
| Print Speed | 80 mm/hr |
| Connectivity | Ethernet |
| Material | Powder-based materials (e.g., zp150, zp131) |
| Build Volume | 510 x 510 x 510 mm |
| Layer Thickness Range | 0.089 - 0.102 mm (0.0035 - 0.004 in) |
Describes intended use, limitations, and patents for the equipment.
Lists the sections of the hardware manual.
Explains the 3D printing process and technology.
Identifies key system and printer parts.
Step-by-step guide to prepare the printer for a build.
Steps for setting up a build file in ZPrint.
Instructions for removing finished parts from the build area.
Tasks to prepare the printer's build area before each build.
Procedures for cleaning the printer's service station.
How to check and refill binder, wash, and waste fluid levels.
Explains firmware purpose and installation steps.
Advice for optimizing build setup and part placement.
Guidance on part orientation and verifying print settings.
Steps to initiate and monitor the printing process.
Techniques for removing excess powder.
Steps for part removal and initial depowdering.
Explains infiltrating parts with resins to improve properties.
Procedure for replacing print heads.
Instructions for lubricating axis components.
How to resolve air in fluid lines.
Instructions for cleaning rollers and rails.
Addresses binder application issues.
Troubleshoots software freezing and part warping.
Resolves issues with print heads and fluid lines.
Troubleshoots communication errors.
Lists technical specifications.
Details rear panel connections.
How to reset configurations.
Lists error codes and their meanings.
To Next Page
