Need help?Do you have a question about the Z Corporation ZPrinter 310 and is the answer not in the manual?
Summarizes the manual's chapter structure and content.
Explains the 3D printing technology and process.
Identifies the main hardware components of the system.
Details specific internal parts of the ZPrinter 310.
Initial steps to set up the printer for operation.
Step-by-step instructions for printing a 3D part.
Procedures to finish parts after printing.
Practical advice for part setup, orientation, and handling.
Instructions for utilizing ZCast 500 powder.
Instructions for utilizing zp250 powder.
Steps for powering up the ZPrinter 310.
Process of loading powder into the build area.
Steps to ensure the build platform is ready.
General procedures for cleaning the printer.
Maintenance procedures for the service station.
Procedure to replenish the binder fluid reservoir.
Steps for safely disposing of waste binder.
Steps to establish printer communication.
How to load 3D models into the ZPrint software.
Guidance on positioning parts within the build for optimal results.
Tips for printing parts with unsupported overhangs.
Verifying printer and powder parameters before printing.
Adjusting material-specific settings for printing.
Initiating the 3D printing process and monitoring its progress.
Procedures for safely extracting printed parts.
Removing excess powder from printed parts.
Methods for drying parts to achieve full strength.
Using resins to enhance part properties.
Techniques for joining separate printed components.
Methods for applying paint for aesthetic finish.
Using polyester resin for specific part applications.
Processes for applying a metallic coating.
Applying decorative patterns using hydrographic printing.
Using printed parts as patterns for metal casting.
Creating parts with flexible material properties.
Using printed parts to create molds for forming plastic sheets.
Creating soft silicone molds from master patterns.
Procedure to replace the printer's print head.
Cleaning electrical connectors for reliable communication.
Lubricating the printer's high-speed movement axis.
Procedure to replenish the wash fluid.
Lubricating the printer's slower movement axis.
Lubricating the build and feed piston drive screws.
Steps for replacing the binder fluid tank.
Instructions for adding color to the binder fluid.
Removing air from the binder fluid system.
Interpreting printer status indicators and alerts.
Explanation of safety and operational symbols on the printer.
Key technical parameters and operating conditions.
Guidelines for safe storage of printer materials.
An overview of the ZCast process for metal casting.
Critical safety warnings for ZCast metal casting.
Benefits and capabilities of the ZCast process.
Principles and methods for designing ZCast molds.
Steps required to prepare ZCast molds before metal pouring.
General| Print Resolution | 300 x 450 dpi |
|---|---|
| Connectivity | Ethernet |
| Build Volume | 203 x 254 x 203 mm |
| Layer Thickness | 0.089 - 0.102 mm |
| Power Requirements | 100-240 VAC, 50/60 Hz, Single Phase, 15A |
To Next Page
