56 service@zcorp.com
USING ZBOND
TM
CYANOACRYLATE
Z-Bond cyanoacrylate is an extremely fast setting, low viscosity,
general-purpose infiltration resin. This resin is designed to rapidly
strengthen parts. Z-Bond is a one part, user friendly, no-odor, non-
blooming resin that may eliminate the need for special ventilation. This
resin is easily sanded and enhances the vibrancy of color parts. Z-
Bond 10 (which can be used with starch models) is available in 0.5 lb
bottles and Z-Bond 100 (which can be used with plaster models) is
available in 3.5 ounce bottles and 24 ounce spray bottles.
S
AFETY PRECAUTIONS
• Do not use or handle this product until the Material Safety Data Sheet has been read and understood.
• Wear lab coat, gloves (we recommend Nitrile Examination Gloves), face shield or goggles. Face shield is
required if spraying. Apply in ventilated hood.
• Specialized containers recommended for dispensing and application. System for avoiding spills: Catch pan,
waxed paper, or plastic drop cloth.
• Label disposal materials.
• Wear dust mask when sanding finished parts.
GENERAL APPLICATION NOTES
• Part should be fully dried before applying resin. Resin reacts with water and produces heat. If the part is not
dried, it will heat up the part and produce gas that may be an irritant to the mucous membranes.
• Material can be brushed, dripped or sprayed.
• Material will penetrate between 0.08 - 0.12 inches (2–3 mm).
• Do not over apply the material, as it will pool off the part during cure cycle.
SPRAYING INSTRUCTIONS
• Always spray in a vented hood.
• While wearing all protective equipment, insert the spray trigger nozzle into bottle.
• Use cardboard or wax paper to protect the spraying area from overspray.
• Spray Z-Bond only onto parts that have been oven dried and are free from moisture (this ensures deepest
available penetration and decreases smoking from reaction with water).
• Keeping the tip of the spray bottle 4 – 6 inches (10 -15 cm) away from top of the part begin squeezing the trigger.
• Adjust the tip of the sprayer until the desired spray pattern is reached.
• Apply Z-Bond to all upward facing surfaces and sides of the part. Be sure not to spray the base of the part, as
it will stick to the surface it is sitting on.
• Wait for the top of the part to cure or speed up the process by using an approved Z-Bond accelerator.
CURING INFORMATION
• The part should be placed on a non-stick material (wax paper, Teflon, etc.) or it will adhere to the surface it is
sitting on while curing.
• Wear gloves when handling the parts to avoid contact with uncured resin.
• Parts will attain full strength in two minutes.
To Next Page
Loading...
