47www.zcorp-users.com
PART CONTAINING OVERHANGS
Unsupported overhangs should be placed on the left hand-side of the build. The plaster powder, being extremely
fine, is more fluid in the build box. Placing a fixture underneath overhanging surfaces will reduce the movement
of the overhang. For information on generating fixtures, refer to the ZPrint Software Manual.
Cylindrical features will be more accurate when their axis is parallel to the z-axis. For example, if you were to print
a bottle, the bottle would best be printed standing up, with the mouth of the bottle facing the top of the printer.
1.4
2.0
To Next Page
Loading...
