70 service@zcorp.com
FLEXIBLE PARTS
Material
Por-A-Mold 2030
Preparation
• Read and understand the Material Safety Data Sheet, as well as any directions.
• zp15e parts should be used.
• Be sure the parts are completely dry.
• Wear impervious rubber gloves, glasses, and a lab coat.
• Use adequate ventilation when mixing and applying the material.
Instructions
1. Material should be mixed well at an exact 1:1 ratio.
2. Apply generously. For thin parts, use a brush or syringe. Thicker parts can be
dipped.
3. If the material soaks completely into the part within a minute, apply another coat.
Multiple thin coats of elastomer will enable the part to be best infiltrated.
4. A vacuum chamber will help the material to soak deeper into the part, but is not
required.
5. Excess material can be removed with a paper towel.
6. Let the parts sit on wax paper to cure. Make sure excess material is not dripping
into a puddle on the wax paper. This will be difficult to remove after it cures.
To Next Page
Loading...
