80 service@zcorp.com
CLEANING POGO PINS
In general, there is no need to clean the pogo pins upon replacing the print heads. At times, they may need to be
cleaned due to errors in communication between the print head and printer (such as when receiving Head ROM
errors) or when it is dirty.
To clean the pogo pins, follow the instructions below:
1. Use the alcohol swabs which can be ordered from Z
Corporation (part number 12073).
2. Remove the alcohol swab from the packaging.
3. Crush the plastic casing to release alcohol into the
swab.
4. Open the carriage cover.
5. Wipe the pogo pins.
6. Close the carriage cover.
To Next Page
Loading...
