22 service@zcorp.com
THIS CHAPTER COVERS DETAILED INSTRUCTIONS
ON HOW TO USE ZCAST
TM
500 AND ZP
®
250
POWDER SYSTEMS. IT DESCRIBES HARDWARE
AND SOFTWARE CHANGES NEEDED TO BUILD
PARTS SUCCESSFULLY WITH THESE MATERIAL
SYSTEMS. IF YOU ARE NOT USING ZCAST OR
ZP250 POWDER, PLEASE PROCEED TO
CHAPTER 4, PREPARING THE 3D PRINTER.
FOR INFORMATION AND GUIDANCE OR
ADDITIONAL QUESTIONS, PLEASE CONTACT THE
Z CORPORATION SERVICE DEPARTMENT AT
(781) 852-5050, TOLL-FREE AT (877) 88-
ZCORP OR VIA EMAIL AT
SERVICE@ZCORP.COM.
MATERIAL SYSTEMS
CHAPTER 3
To Next Page
Loading...
