43www.zcorp-users.com
REFILLING THE BINDER BOTTLE
Refill until binder fluid
reaches the neck of bottle.
Warning: Use only binder supplied by Z Corporation. Use of any other material will impact the performance
and/or safety of the ZPrinter 310 System and will void warranty and service contracts.
1. Unscrew the black cover of the binder bottle.
2. Fill with binder fluid until liquid reaches the neck of the
bottle. Hold bottle sideways to avoid spilling binder.
3. Replace the binder bottle cover.
CHANGING THE PRINT HEAD
Change the print head if necessary. The ZPrint Software will alert you if your print head is old and may not
complete the build. For more information about changing print heads, please refer to Chapter 8, Maintenance.
Technical Tip....
If you fill the binder bottle after you change the print head, there is enough binder to last until the print head’s
normal life is achieved.
To Next Page
Loading...
