93www.zcorp-users.com
SYMBOLS USED
THE FOLLOWING SYMBOLS ARE USED ON THE ZPRINTER 310 SYSTEM:
This is the international symbol for ‘standby power’. It is used on the ZPrinter 310 power switch. The printer is
partially powered as soon as you plug it in. The power switch is momentary contact and toggles the machine from
idle mode to full power on mode.
This is the international symbol for ‘warning’ or ‘caution’. When it appears on the exterior of the equipment, it
indicates the need to consult your manual for further information.
SYSTEM SPECIFICATIONS
Operating Conditions: 68 to 85ºF (20-29ºC), 20 to 60% Relative Humidity, non-condensing.
Lithium Battery: Internal to the ZPrinter 310 is a lithium coin cell type battery. This may be any one of the
following: Type: CR2032, either Maxell, Panasonic, Renata, Sanyo or Sony.
PLEASE NOTE: This battery is not in a user accessible area and is not user replaceable. The expected lifetime
of the battery is in excess of five years. Replacement will be handled by your Z Corporation customer service
representative.
FCC Notice: Note: this equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interferance to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his
own expense.
CENELEC Class A Warning: Note: this equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to EN 55022. Class A devices are for office and light industrial environments, and
are not generally suitable for home use.
WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
To Next Page
Loading...
