OPERATION
Powering ON/OFF
· When device is connected via the USB car charger, it will Automatic:
automatically detect engine ignition and turn on.
· Press and hold the “Power” button for 3 seconds to power on/off device.Manual:
Indicator Lights
· Recording videoFlashing Red:
· ChargingBlue Light:
Recorded Video Files
Videos are recorded and saved to the memory card as multiple video clips. Once
the memory card is full, the “Loop Recording” feature automatically overwrites
the earliest unprotected saved file. This prevents long duration video clips from
being lost in a single overwrite. Video clip duration can be set to 1, 3 or 5 minutes
inside the “Menu Setting” menu. Video clips can be played directly on the display
screen, or copied/stored and played on a computer.
· Access General Settings Menu: In standby mode (device not recording or capturing
images) pressing the “Menu” button twice will highlight the “Menu Settings” menu.
Use the “Up” and “Down” buttons to navigate. Press “OK” button to confirm. Short
press “Menu” button while in the menu to exit.
· Press “Menu” button to return in system menu.Return:
· In the event of an emergency, it is important to save Emergency Video Protection:
and protect recorded video files so that they are not erased by the “Loop Recording”
feature. With “Crash Detection” feature enabled, this device automatically protects
video files when a significant vibration has been detected. However you can manually
protect any video clip by pressing the “Menu” button during a video recording. This
will protect the saved clip/file from being automatically deleted in the future. A warning
icon appears on screen to signify the file has been successfully protected. Press the
“Menu” button again to remove protection.
"Menu" Button
6
To Next Page
Loading...
Need help?
General
