8
PHOTO CAPTURE MODE
Driving Mode
The X1 Camera can operate like a car dash camera in Driving Mode. The camera
will automatically power on and begin video recording when connected to power.
Once disconnected from power it will stop recording and automatically shut down
after a period of time. If operating as a car dash camera, Driving Mode is best used
alongside Loop Recording for the most efficient storage of video clips. Feature
enabled/disabled inside Settings > All Modes > Driving Mode.
Photo Resolution
Set the Photo Resolution of the X1 Camera inside Settings > Photo Capture >
Photo Resolution.
Timer
Delay the capture of a single photo by up to 20 seconds after pressing the Shutter
button. Self-Timer can be set inside Settings > Photo Capture > Self-Timer.
Auto
Capture photos at set intervals in a continuous loop using Auto-Shoot. Set the
interval timer for capturing photos between 3, 10, 15, 20 and 30 seconds. The
first photo will be captured the selected interval time after pressing the Shutter
button in Photo Capture mode. An audible beep indicates each second passed
between photos being captured. The X1 Camera will continue to take photos
until the Shutter button is pressed again. Auto-Shoot intervals set inside
Settings > Photo Capture > Auto-Shoot.
Photo Burst
The X1 camera will capture several photos in quick succession in burst mode.
Set between 3, 5 and 10 photos taken continuously after pressing the Shutter
button in Photo Capture mode. Burst can be set inside Settings > Photo
Capture > Burst.
duration video clips from being lost in a single overwrite. Set video clip durations
between 2,3 or 5 minutes. Video clip duration set inside Settings > Video
Recording > Loop Recording.
To Next Page
Loading...
Need help?
General
