Z-Wave Aeotec 7 Pro - Screw Terminal; Link testing; Scene Controller

Screw Terminal
The product must support the interconnection of external binary sensors as well as actuators
and dry-contacts. The product allows interconnection with external sensors/actuators via 3-pin
screw terminals with the following pinout:
 #1: Ground
 #2: Digital Input
 #3: VCC (direct battery supply)
VCC + Ground terminals can be used to externally power the sensor with a 3.6V battery or special power
adapter (which is not included in the scope of delivery). Digital + VCC is used to connect the external dry
contact.
Link testing
When activated by configuration parameter #5 the device can perform a link test. Double-clicking the
tamper will start the process. As a result, the GREEN LED will blink two times in case of success and the
RED LED will blink two times in case of failure.
Scene Controller
When activated by configuration parameter #14 the device can perform as a scene controller. Digital +
VCC is used to connect the scene button. The external dry contact will then act as a scene controller with
a total of 7 scenes that can be activated:
 1 - Contact Pressed 1 time
 2 - Contact Pressed 2 time
 3 - Contact Pressed 3 time
 4 - Contact Pressed 4 time
 5 - Contact Pressed 5 time
 6 - Contact held down
 7 - Contact released
The device sends the following notifications to the central controller:
 Window Opened(0x06 - 0x16)
 Window Closed(0x06 - 0x17)
 Tamper Removed(0x07 - 0x03)
The device sends the following sensor binary reports to the controller:
 Tilt(0x0B)
Node Information Frame