Need help?Do you have a question about the Z-Wave Aeotec 7 Pro and is the answer not in the manual?
General| Brand | Z-Wave |
|---|---|
| Model | Aeotec 7 Pro |
| Category | Security Sensors |
| Language | English |
Resets the device to factory defaults without controller involvement.
Advises on battery handling and avoiding mixing types/levels.
Process of adding a device to a Z-Wave network via manual action.
Process of removing a device from a Z-Wave network via manual action.
Reports window opening angles using binary sensor tilt-type command class.
Defines groups for device control relationships and their maximum nodes.
Selects internal magnet sensor or external terminal input for notifications.
Configures the operation mode for dry contact terminals.
Sets the state based on magnet proximity to the sensor.
Defines which events trigger the red LED indication.
Enables Z-Wave range test activated by double-clicking the tamper.
Defines magnet switch status triggering commands for Association Group 2.
Specifies commands sent to devices in Association Group 2.
Sets the BASIC command value for 'On' events in Association Group 2.
Sets the BASIC command value for 'Off' events in Association Group 2.
Defines a delay before sending the 'On' command frame.
Defines a delay before sending the 'Off' command frame.
Sets a delay for tamper alarm cancellation notifications.
Configures whether tamper alarm cancellation events are reported.
Enables or disables the central scene function.
Enables or disables the tilt sensor functionality.
Sets the state when the tilt sensor is in an OFF state.
Defines magnet switch status triggering commands for Association Group 5.
Specifies commands sent to devices in Association Group 5.
Sets the BASIC command value for 'On' events in Association Group 5.
Sets the BASIC command value for 'Off' events in Association Group 5.
Adjusts the tilt sensitivity for the tilt sensor.
Enables or disables binary sensor reports for door/window state.
Configures low battery reporting based on a threshold.
Sets the interval in hours for battery status reports.
Resets configuration parameters or the entire device to factory defaults.
To Next Page