Z-Wave Aeotec 7 Pro - Parameter 15: Tilt Sensor Functionality; Parameter 16: Tilt Sensor State; Parameter 17: 5 th Association Group Trigger; Parameter 18: Command Sent to Devices of Association Group 5

This parameter enables/disables the central scene function.
Size: 1 Byte, Default Value: 1
Setting Description
0
Disabled
1
Enabled
Parameter 15: Tilt Sensor Functionality
This parameter enables/disables the tilt function.
Size: 1 Byte, Default Value: 1
Setting
Description
0
Disabled
1
Enabled
Parameter 16: Tilt Sensor State
This parameter allows to set in what state is door/window when the tilt is in an OFF state.
Size: 1 Byte, Default Value: 0
Setting
Description
0
OFF when sensor is vertical
1
ON when sensor is vertical
Parameter 17: 5th Association Group Trigger
This parameter defines the status of the magnet switch that causes sending a BASIC command to all
devices of Association Group 5.
Size: 1 Byte, Default Value: 0
Setting
Description
0
Switch after Open and Close
1
Switch after Open
2
Switch after Close
Parameter 18: Command Sent to Devices of Association Group 5
This parameter defines which commands is sent to 5th Association Group
Size: 1 Byte, Default Value: 2
Setting
Description
0
On
1
Off