Z-Wave Aeotec 7 Pro User Manual

2
On and Off
Parameter 19: BASIC command value sent to 5th Association Group on On event
This is the BASIC command value sent in case of On event.
Size: 1 Byte, Default Value: 255
Setting
Description
0
-
99
Value
255
Value
Parameter 20: BASIC command value sent to 5th Association Group on Off event
This is the BASIC command value sent in case of Off event.
Size: 1 Byte, Default Value: 0
Setting
Description
0
-
99
Value
255
Value
Parameter 21: Tilt sensitivity
With this parameter, you can adjust the tilt sensitivity if the tilt is too low or too strong. Value 0 does not
disable Tilt Sensor, it just sets it to a minimum.
Size: 1 Byte, Default Value: 50
Setting
Description
1
-
100
Sensitivity
Parameter 22: Enalbe/ disbale Binary Sensor report
Backwards compatibility, Binary Sensor for door/window state. （Sensor type=0x0A）
Size: 1 Byte, Default Value: 0
Setting
Description
0
Disable
1
E
nable
Parameter 23: Report low battery report when level goes under threshold setting
Size: 1 Byte, Default Value: 20
Setting
Description
1
0
-
50
10
-
50%
Note: once the Sensor wakes up, it will check the threhold value.

Z-Wave Aeotec 7 Pro Specifications

General

Brand	Z-Wave
Model	Aeotec 7 Pro
Category	Security Sensors
Language	English